Quick Answer: How To Reset Club Car Computer?

Is there a reset button on a Club Car golf cart?

Check around this supply for a small red button that may or may not be labeled “Reset”. Press and hold this button for a few moments and then release it to reset the motor. Put the cover back on your golf cart motor and seal it back with the screwdriver.

Where is the reset button on club car motor?

Expose the motor (you’ll probably need a screwdriver to remove the cover), and look for a red button. It is usually near the main power source, where most of the wires are connected. Once you’ve pressed the button to reset the motor, reassemble the cart, charge up the batteries, and give it a test run.

Where is the reset button on my golf cart?

Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button. Push the button to reset the motor.

You might be interested:  Quick Answer: How To Tell When My Car Computer Is Bad?

How do I test my club car onboard computer?

Is My Club Car Golf Cart on Board Computer (OBC) Bad?

  1. Set the voltage meter to DC Volts 200V.
  2. Take voltage from the positive side of the charger port/receptacle to the negative on the battery pack loop of batteries.
  3. There should be voltage read on the battery back, this may vary based on the charge.

How do I know if my club car charger is working?

If the Club Car’s computer is working correctly, the relay should make a “click” sound when you plug in your charger. If it does not, then you could easily have a blown fuse. If you check the fuse and it is okay, then you could also have a damaged relay, although this is rare.

How do you test a club car motor?

To properly test the motor, connect a fully charged 12-volt battery to the electric motor’s battery posts.

  1. Park the club car on a level surface and turn the key to the “off” position.
  2. Jack the rear of the club car up and place jack stands at the proper rear jacking points.

What do the lights mean on a club car charger?

A green light flashing on the battery charger of your golf cart usually indicates the charge level of the battery. Short green flashes mean the charge level is below 80%, where long flashes mean the charge level is above 80%. If it is one solid green light it indicates the golf cart’s battery is fully charged to 100%.

How do you reset a golf cart battery meter?

Reset the battery meter. Unhook power to the battery meter for 10 minutes. This will reset the battery meter.

You might be interested:  Often asked: Where Do I Plug In Car Computer 2000 Mustang?

How do you fix a golf cart that won’t start?

First, try this: turn the key switch on, hit the accelerator, and check for a clicking noise. If you don’t hear clicking, it’s time to take a look at your cart’s batteries. Make sure the battery is fully charged and the terminals are cleaned and secure. Next, see how the water level in the battery is holding up.

How can I speed up my Club Car golf cart?

6 Ways You Can Make a Golf Cart Faster

  1. Add More Torque to Your Golf Cart.
  2. Upgrade Your Golf Cart’s Motor.
  3. Improve the High-Speed Controller of the Cart.
  4. Add Better Golf Cart Tires.
  5. Use a Higher Powered Golf Cart Battery.
  6. Watch the Weight in Your Golf Cart.

How do you bypass the key on a golf cart?

This process includes these steps:

  1. Turn off the ignition switch to minimize your risk of electrocution.
  2. Locate the wires for your cart’s ignition switch.
  3. Use wire snips to cut these wires away from their connectors.
  4. Touch the engines together carefully to bypass the ignition switch and send power to your engine.

What does a speed sensor do on a golf cart?

The speed sensor on a golf cart is used to interpret the rpm of a motor. From there, it then passes this information to the speed controller found in the cart. The point of this device is to keep control of the many motor functions that exist. This includes regenerative braking and a protection called roll away.